Ft Rubber 25
Ft Rubber 25
Check out this page if you are searching for Ft Rubber 25
 |
 Body Solid 400 Lb Rubber Grip Olympic Set with 7 Bar  US $525.00
|
 100 sq ft Commercial Rubber Gym Flooring 4 x 25 ft Mat Firestorm Red US $210.00
|
 Ivanko olympic rubber bumper plates 2725 kg in weights US $3,324.20
|
 York Barbell 275 lb Solid Rubber Bumper Plate Set With 7 ft Hard Chrome Bar US $844.99
|
 Body Solid 300 Lb Rubber Grip Olympic Set with 7 Bar US $399.00
|
 100 sq ft Commercial Rubber Gym Flooring 4 x 25 ft Mat US $200.00
|
 Yukon Ftiness Body Solid 300 lb Olympic set OLY 230 US $525.00
|
 100 sq ft Commercial Rubber Gym Flooring 4 x 25 ft Mat 20 Brick Red US $210.00
|
 Body Solid 500 lb Rubber Grip Olympic Weight Set Bar US $898.00
|
 Body Solid 400 lb Rubber Grip Olympic Weight Set Bar US $730.00
|
 Body Solid 300 LB Rubber Grip Olympic Weights Set Bar US $624.99
|
 Body Solid 400 LB Rubber Grip Olympic Weights Set Bar US $749.99
|
 Body Solid 500 LB Rubber Grip Olympic Weights Set Bar US $899.99
|
what amp will i need to power this sub?
Size: 10 inch
Rec. Sealed Box Dims: .33 - .66 cu.ft.
Rec. Ported Box Dims: .6 - .75 cu.ft
Free Air Usage: not recommended
Sensitivity: 85 dB
Frequency Response: n/a
Recommended RMS Power: 2,000W
Peak Power Handling: 2,500W
Impedance: dual 2 ohms
Heat-hardened, ultra-rigid aluminum cone
Nitrile-butyl rubber (NBR) surround with large roll profile
Massive proprietary die-cast aluminum basket
Patent-pending dual gap geometry motor assembly
Dual flat spiders
Raised vented spider tower
Die-cast mounting clamps
Rubber sealing wrap gasket
Double stacked internal & external magnets
Vented pole piece
3" two-layer copper voice coil on aluminum former
Proprietary AngleLock wire terminals
Optimized performance in high-output sealed or ported enclosures
Mounting depth: 7.5"
Mounting hole diameter: 9.25"
Warranty: 1 year
its got twin voice coils to yea?
Thanks Every1
its a orion 10.2
Its A Orion 10.2 H2 10inch
It is a DVC sub, 2-ohm per coil. You need an amp that is rated at 2000 watts RMSx1@4-ohms or @1-ohm. That is for one sub. Now, you can use a less powerful amp. You can use an amp rated at 500 watts RMS if you want. It won't be as loud though. What box will you be using it in?